when the chip is flat on a table for 4 seconds.The Super chip will stop transmitting (but will stay on) in these cases: There is no need to charge the super chip, the battery is good for 500-800 shows. When the chip is 90 degrees angle - you will get short pulses.When the shape is on top - you get 2 vibrates.When the number is on top - you get 1 vibrate.You need to select the chips one by one and not all of them at the same time because if they all move at the same time you will not know which is which.Īfter the identity of the chip is determined, the system will automatically tell you the position that the chip is currently at. As we described earlier, the number of vibrations is different for every chip: When the chip moves or change its position, the receiver will vibrate. In order to know which chip was selected, all 3 chips must be placed on a surface or in the pockets for at least 20 seconds. The Super-chip Full Set will allow you first to know which color chip was lifted from the table or taken out of a pocket and after a few seconds it will tell you the position of the chip. There is no off switch for the chips, they start up automatically after you do one of the steps as described above. Once you have turned on the chip, it will stay on for 16 minutes. The best way to keep your Super chip safe is to carry it inside the mini carrying case we provided to you. Keep the chip away from magnets -if a magnet is close to the chip it may drain the battery of the chip. If you pass that side of the chip next to the magnet you were supplied with (or any other magnet for that matter), It will automatically reset the system and turn on the chip. On the top part of each chip (above the numbers) you have a magnetic sensor. You will need to take the chips out of the case and set them on the table. If you choose, you can use the magnet on the bottom of the case to turn on the chips.Once every chip is on, the set will be ready to use. Be close to the chip when you turn it on. This will happen because the system understands that the chip is on a table. You should feel the vibrations from the receiver which will vibrate several times according to which chip you took out:Īfter every time you turn a chip on, let it sit for a few seconds until it stops transmitting. Every time you take a chip out of the case, put it flat on a table and wait up to 10 seconds. You can turn the chips on by taking them out of the case one by one.You have 2 options for turning the chips ON: Green light will mean that the battery is full, and a red light means that the battery is weak and should be charged. *If you don't turn on the receiver first it will not turn on the chips. A micro USB cable to charge the receiverįirst turn on the receiver using the on/off switch.Please watch the video explanation and read the full instructions before using the chip!
0 Comments
Leave a Reply. |